De-sta-co 662P Manuel d'utilisateur

The Driving Force in Automation“WARNING”®This is a controlled document. It is your responsibility to deliver this information to the end user of the C

PARTS LIST FOR 250P INDEX DRIVE (STANDARD CONFIGURATION)ITEM NO. PART NUMBER DESCRIPTION1 ...24C179

PARTS LIST FOR 250P CONTINUED23 ...24A032286009800 STUD FOR 5/8 DIA. FOLLOWER...

PARTS LIST FOR 387P CONTINUED7 ...26B01553003112 CARTRIDGE CLOSED OUTPUT...

512P & 662P12

PARTS LIST FOR 512P INDEX DRIVE (STANDARD CONFIGURATION)ITEM NO. PART NUMBER DESCRIPTION1 ...28D089

PARTS LIST FOR 512P CONTINUED19 ...95A33003010000 MAGNETIC PLUG20 ...

PARTS LIST FOR 662P CONTINUED...30B02649007002 INPUT SHAFT DBL EXT (W/O REDUCER)...

NOTES16

USA 6/99 0068

TABLE OF CONTENTSIntroduction... 2Warn

INTRODUCTIONThis service manual pertains to the disassemblyand assembly of CAMCO’s Parallel Series IndexDrives models 250P, 387P, 512P, & 662P.The

B. Remove the main housing screws. Thesehold the upper and lower housingstogether.C. Remove all bearings cartridge capscrewson the upper (smaller par

B. After removal of the cartridge, tap the shaftin the opposite direction, and remove theother cartridge in the same manner.NOTE: You must remove the

Fig.6 Removing follower wheel fasteners.B. Use arbor to press follower wheel ontoshaft. Be sure the fastener and dowel holesline up. Coat shaft and bo

3. Use an arbor to press the bearing cups into thecartridges. Coat the outside of the cup and thebore of the cartridge with an anti-seize lubricantpro

D. Repeat procedure “C”.E. Check for smooth action by turning theinput shaft. Check also the input shaftendplay as described in procedure “4D”- Instal

250P & 387P8