De-sta-co INDEX DRIVES GENERAL SERVICE MANUAL Manuel d'utilisateur télécharger pdf (Page 7)

Index Drive Oil Capacities (Approximate)

For indexers mounted in the normal* position. Consult IMC for units not listed.

Model No. US. Metric Model No. U.S. Metric

(quarts) (liters) (quarts) (liters)

80RDM

Grease filled**

40RGD/S 6 oz. 0.2

601RDM 2 2 50RGD/S 16 oz. 0.5

902RDM 3 3 70RGD/S 20-24 oz. 0.6-0.7

1100RDM 8 8 80RGD/S 30-38 oz. 1-1.1

1305RDM 9 9 110RGD/S C/F C/F

1800RDM 36 34

350RGD/S 1 1.4

425RD 2 2 500RGD/S 5 4.7

800RD 5 5 700RGD/S 10 9.5

1301RD 14 13

1801RD 36 34 1100RNG C/F C/F

1550RNG C/F C/F

250P 1 1 2050RNG C/F C/F

387P 2 2

512P 5 5 750E C/F C/F

662P 10 10 950E 10 gallons 38

900P 20 19 1150E 25 gallons 95

1200P 48 45 1550E 40 gallons 152

1800P 95 90 2050E 45 gallons 171

2750E 75 gallons 285

401RA (C) 1 1

512RA(CC) 2 2 150RPP 2.5 2.4

662RA(CCM) 6 6 300RPP 4 4

663RAD(DR) 4 4 500RPP 10 9

900RAD(GH) 6 6 900RPP 48 45

* Normal indexer mounting position is output vertical over input on all models except the "Parallel series" (P)

in which normal mounting is output horizontal, even with input. “Output Vertical” refers to the direction of the

center of rotation. For dial-type indexers, this is the position with the dial horizontal.

** “Grease-filled” units are shipped with grease. Grease should only need to be added if the unit is

disassembled for rebuild or repair.

C/F: Consult IMC for information

Oil Seal Installation Recommendations

IMC recommends that all seals be replaced any time the device is being disassembled regardless

of whether they are damaged or not. Most damage to oil seals occurs at assembly when

recommended seal installation procedures are not followed.

1. Check dimensions -- to be sure that shaft and bore diameters match those specified for the seal

selected.

2. Check seal -- for damage that may have occurred prior to installation. A sealing lip that is turned

back, cut or otherwise damaged should be replaced.

3. Check bore -- to see that the leading edge is deburred. A rounded corner of chamfer should be

provided.

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

De-sta-co INDEX DRIVES GENERAL SERVICE MANUAL Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel De-sta-co INDEX DRIVES GENERAL SERVICE MANUAL