De-sta-co INDEX DRIVES GENERAL SERVICE MANUAL Manuel d'utilisateur télécharger pdf (Page 20)

IMPORTANT!!!

Cam Follower Installation Procedure

The H9 thru H32 (.287” thru 1.00” diameter) Cam Followers require a Steel Ball/Set Screw

and an insertion gage for installation. The steel ball/set screw is used to anchor the cam

followers to the follower wheel and the insertion gage kit is used to insure proper

installation. The new cam followers need to be pressed onto the follower wheel to the

position prescribed by the gage (if they are pressed in too far, the will not turn freely).

Cam Follower Installation Procedure

1. Obtain spare parts kit, cam followers and insertion gage kit.

2. Select proper insertion gage. The spot-faced type gage should be used if the cam

follower mounting surface is spot-faced. If no spot face is present, the flatted type gage

should be used (see gage illustration, above).

3. Place insertion gage around the outer diameter of the cam follower while pressing onto

the follower wheel.

4. Refer to the following chart to determine if the steel ball and set screw or the set screw

only* should be used for anchoring the cam follower. The anchoring hardware may not

always align exactly with the groove on the cam follower but it will always align within an

acceptable range. The cup point style set screw is always required.

* If steel balls and set screws were supplied with the original unit, continue using steel balls and set screws

(reuse original set or use set provided in the spare parts kit).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Pas de commentaire

De-sta-co INDEX DRIVES GENERAL SERVICE MANUAL Manuel d'utilisateur Page 20