De-sta-co F5-B AC Inverter Drive Manuel d'utilisateur télécharger pdf (Page 33)

4.1.1 Keypad

Pressing ENTER only clears the fault message in the display. In

the Inverter status display (CP. 2), the fault is still displayed until

the inverter has been reset. In order to reset the fault itself the

cause must be identified and removed, than a reset signal applied

to terminal 16, F5-Basic, or a power-on reset (cycle supply voltage

off and then on) must occur.

error

When switching on the KEB COMBIVERT F5, the value of parameter CP.1

appears in the operator display. (see "Drive Mode" to switch the keypad

function)

The function key

(FUNC) changes

between the

parameter value and

parameter number.

With UP (

) and

DOWN ( ), the

value of the

parameter number

is increased or

decreased.

Generally; when a value is changed, parameter values are immediately

accepted and stored nonvolatile. However, with some parameters it is not

useful that the adjusted value is accepted immediately. In these cases the

adjusted value is accepted and stored nonvolatile by pressing ENTER.

If a drive fault occurs during operation, the display changes to the drive

fault message. The drive fault message in the display is cleared by

pressing ENTER.

Operation of the Drive

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 55 56

Pas de commentaire

De-sta-co F5-B AC Inverter Drive Manuel d'utilisateur Page 33