De-sta-co F5-B AC Inverter Drive Manuel d'utilisateur télécharger pdf (Page 46)

Drive Mode

4.6 The "Drive Mode"

The Drive Mode is a operating mode of KEB COMBIVERT that permits the

manual starting of the drive through the keypad display unit. After applying

a signal to the control release terminal 16, the set value (speed ref.) and

rotation setting are effected exclusively over the keypad. In order to

activate the Drive Mode the corresponding password (500) must be

entered in CP.0. The display switches over as follows.

Direction of rotation

F=forward, r=reverse

Status

noP = "control release" deactivated

LS = neutral position

Set frequency can be changed

with the UP/DOWN keys while

holding the FUNC/SPEED key

4.6.1 Start / Stop

Drive

4.6.3 Speed

setting

4.6.2 Changing

the Direction

of Rotation

To exit the Drive Mode the inverter must be in status “stop” (Display noP

or LS). Press the FUNC and ENTER keys simultaneously for about 3

seconds to leave the Drive Mode. The CP-parameters appear in the

display.

4.6.4 Leaving

"Drive Mode"

Modulation blocked,

Drive in standby mode

Drive decreases to 0 Hz and

switches the modulation off

Drive accelerates up

to the adjusted set

value (speed ref.)

Drive operates with adjusted set

value (speed ref.)

Drive changes direction of rotation

The display changes when the

FUNC/SPEED key is pressed.

The set frequency is displayed.

for 3 seconds

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 55 56

Pas de commentaire

De-sta-co F5-B AC Inverter Drive Manuel d'utilisateur Page 46